Sandpaper Grit Selection by Material and Task
Start with the surface you have
Choose a starting grit that can address the defect you need to remove. Consider the workpiece material, existing scratches and the finish required by the next process. A rough surface and a nearly finished surface call for different starting points.
The grit number is one part of the specification. Keep the abrasive format, grain, backing and tool setup in view when comparing products.
Choose the job before the number
| Starting condition | Your selection question | What to check next |
|---|---|---|
| Rough stock or pronounced surface marks | What must be removed before the finish can improve? | Trial a suitably coarse abrasive on a spare piece and inspect the new scratch pattern. |
| Planed or shaped bare wood | Are there machining marks or other blemishes? | Use the wood and finish suppliers' guidance to select a starting grade. |
| Surface already sanded | Have the previous scratches been removed evenly? | Inspect under consistent light before moving to a finer step. |
| Primer, filler or an existing coating | What preparation does the coating system specify? | Use that system's recommended grade and abrasive format for the current stage. |
| Metal before coating or finishing | What surface condition does the next process require? | Match the specification and manufacturer guidance for the alloy and operation. |
| Composite part | What is the starting condition and final requirement? | Use the composite and coating system's guidance and test the complete sequence. |
A bare-wood starting example
Norton's bare-wood guide gives 80 grit as a typical starting point for planed or shaped wood with imperfections, and 100 grit where blemishes are absent. Use that as a starting example for a trial. Confirm the final sanding step with your finish supplier and test the finish on the same species of wood.
Manufacturer reference — Norton bare-wood sanding
Plan a sequence you can inspect
Work through the steps needed to remove the scratches from the previous abrasive. Inspect the surface between steps and keep your test conditions consistent. Record the exact abrasive line and grade when a sequence produces the finish your shop needs.
A repeatable shop record includes the substrate, starting condition, abrasive part numbers, tool setup, sequence and final coating or finish. Add a photo of the approved sample so another operator can compare the result.
Buying a replacement
Check the marking on the abrasive or packaging. Record the grade exactly as printed, including a prefix or suffix such as P or + where present. Match the manufacturer part number when you need to reproduce an established process.
For a new sanding job, choose the format that fits your tool or block first. Then compare the available grades for your material and task.
Shop hook-and-loop sanding discs
Common questions
What grit should I start with?
Start with the defect, material and required finish. Test a grade that removes the defect without creating unnecessary work for later steps.
When should I move to the next grit?
Inspect for the previous scratch pattern and for an even surface. Keep an approved sample and the sequence that produced it.
Can I use the same sequence for wood, metal and composites?
Choose a sequence for the substrate and the finishing process. Record each approved process so operators can repeat it.
Additional editorial reference: Norton composite sanding considerations